So, I’m removing the drivers side fender, so I can get to the connection between the Exhaust Manifold and the y-pipe, on my 2005 Jeep Wrangler Unlimited 4.0L engine. It pans out in the end, but wow, what a job! A bit of a snowball effect, and some words of wisdom for when your project snowballs!

Next video! I’ll be replacing the oil pan gasket and rear main seal!

Join The SWBCrawler Community! at https://www.swbcrawler.com/community

For 10% off on https://www.yeswelder.com, use the promo code SWBFAB

Dont forget to check out https://www.swbcrawler.com
I’m on Patreon too!: https://www.patreon.com/swbcrawler
If you want SWBCrawler Swag, check out my store! https://www.swbcrawler.com/shop

Share via
Copy link
Powered by Social Snap